News

  • LEDWhy can outdoor wall washers be widely used?

    Third, the LED outdoor wall washer has a very good moisture-proof and shock-proof effect, so there is no need to worry about the damage caused by the sun and rain. Fourth, LED outdoor wall washers are more energy-efficient and energy-saving than traditional wall washers. Large-area long-term use can also save objective electricity costs for large cities. Moreover, LED outdoor wall washers are not easy to release harmful substances, and are environmentally friendly and will not damage the environment. Fifth, the LED outdoor wall washer is extremely quick to install, eliminating the troublesome installation steps and saving installation costs. And it is good for updating protection. Article from LED outdoor wall washer

    2019-03-21

  • LEDThere are several ways to keep the line lights waterproof.

    Semi-casing Epoxy waterproof or semi-casing glue waterproof, that is, the bottom is a semi-casing sleeve, and then do the glue or potting treatment. 4. Full casing glue filling waterproof or full casing pumping waterproof, which is the high level of waterproofing of LED line light strips at that time, can be completely used in water. Article from LED line lights

    2019-03-21

  • What are the causes of LED outdoor wall washers burning?

    If you use a low-pressure wall washer to connect to high-voltage power, it is also very simple to cause it to burn. For example, if the wall washer used is a low voltage 24V, and the domestic common voltage is 220V, if the power is directly applied during the installation, the internal capacitance of the LED outdoor wall washer will not be able to withstand such a strong voltage. And caused the phenomenon of wall washer burning. 3, wall washer equipment matching fault If the resistance and capacitance on the wall washer circuit board are faulty, the time-division wall washer will also cause short-circuit spontaneous combustion due to excessive current. Therefore, this requires the wall washer to check whether the current is normal before leaving the factory. Article from LED outdoor wall washer

    2019-03-21

  • Which places are suitable for LED outdoor wall washers?

    outdoor landscape lightingBecause LED outdoor wall washers can be well integrated with urban landscapes, good lighting effects can be achieved in recreational spaces such as urban paths, decks, waterfronts, and horticultural areas. Concealed LED outdoor wall washers are particularly popular. 4, building exterior lighting Projecting a certain area of the building, because the LED outdoor wall washer light source is small and thin, the development of linear projection has become a major advantage. It is quick to install and can be installed horizontally or vertically, providing a broader design for night lighting design. The space is commonly used for lighting work in modern and historic buildings. Article from LED outdoor wall washer

    2019-03-21

  • How is the LED flood light waterproof?

    The waterproof grade IP66 is interpreted as “electric appliances installed on the deck to prevent damage caused by large waves” 3, waterproof rating IP67 analysis is "electrical appliances immersed in water for a certain period of time or water pressure below a certain standard, to ensure that damage caused by water immersion." Therefore, in principle, IP65, IP66 and IP67 can not be immersed in water for a long time, it is best to use IP68 LED flood light. The IP68's LED floodlights can be indefinitely sunk at a specified water pressure to ensure no damage due to flooding. Article from LED flood light

    2019-03-21

  • LEDThe shape of the spotlight can be divided into several categories

    Floodlight classification three: a symmetry A symmetrical projection light intensity curve is only required to have a plane of symmetry. The luminaire is selected from an asymmetrical cylindrical reflector or a symmetrical cylindrical reflector plus a light-limited grid. The most typical is the sharp cut-off block retracting light distribution. This type of light intensity spreads a single lamp to achieve a more satisfactory illumination spread. Floodlight classification four: asymmetric shape Light intensity curves such as asymmetrical light types have no symmetry plane. The main purpose is to use the mixed light fixtures of different kinds of light sources with different light intensity distribution and the special lamps designed according to the specific lighting requirements of the application place. Article from LED flood light

    2019-03-21

  • LEDWhere are the line lights applied?

    Bar: Semi-open kitchen bar, which can choose line ceiling lamps for functional lighting. Front of the mirror: basic lighting. The mirror at the entrance is the first to serve as a plucking device. The combination of basic lighting (ligen line ceiling lamp) + functional lighting (wall lamp) in front of the mirror meets the lighting requirements of the utility area. 5. Bedroom: The lighting of the wardrobe area is mainly used for functional lighting. Article from LED line lights

    2019-03-21

  • LEDWhat are the characteristics of the line lights?

    The power supply of the LED line lamp is installed in the flexible plastic, and the power supply path is completely covered. The operation does not have to worry about the risk of water and electricity, and the insulation and water resistance are particularly good. 4. Because of its high weather resistance, it can be used in outdoor environments. Whether it is temperature changes, it is still wind and rain that will not cause damage. It is not easy to break and has a long service life. Article from LED line lights

    2019-03-21

Previous page12Next page Go to No.

Copyright © 2018 Guangdong Guangzhidian Lighting Co., Ltd.
Technical SupportJiangmen website construction